Wall on Grade Foundation
Simple and cost effective, but limited in design capabilities. A wall on grade is just as simple as it sounds. If the bearing capacity of the soil is moderate to high and the load from the structure is light then a typical spread footing can be omitted. In most foundations an 8” wide foundation wall is used so the bearing area would only be .66ft per linear foot. If the soil bearing capacity is 2,000psf the foundation could only support 1,332plf and that must include the weight of the foundation wall. Therefore, you will find in most situations that the wall on grade foundation can only support light structures.
I have used a wall on grade foundation for detached garages and small homes when saving every dollar counts. The walls can be constructed by trenching and setting forms as needed above grade or excavating for a typical crawlspace and setting forms for the depth required for frost depth.
The wall width does not need to be only 8”. You may find it cost effective to use a wall on grade that is 10” or 12” wide for a 36” tall wall in lieu of a spread footing. The volume of concrete may be higher for the wall on grade as the width of the wall increases, but you can construct the wall with a single pour in lieu of two pours; footing then foundation wall.
A wall on grade foundation can sometimes be mistaken as the same foundation type as a turn down edge slab-on-grade. The difference between a wall on grade and a slab-on-grade is the separation of the foundation from the slab. For a wall on grade the bearing area is only of the wall, and for a slab-on-grade turn down edge you can also take into account a percentage of the slab surface for bearing. You can read more about the slab bearing area from a previous discussion about post tension slab on grades and bearing area here.
Fails with Swelling Soil
Limited Design Capacity
Originally posted 2009-10-06 00:01:51.
- Spread Footing Foundation
- Value Engineering of Slab-on-Grade Foundation
- Straight Shaft Drilled Concrete Pier Foundation
- Structural Engineer’s Decision On Soil Bearing Area Used For Post Tension Slabs
- Free Review of Structural Plans for Value Engineering
- Foundation Walls Ready to Pour at Silver Rock Manor
- Form Work for Footing in Place at 1620 S Fillmore in Denver
- New Trends in Concrete Formwork
3 Responses »
- Different Structural Foundation Types | Architecture, Engineering & Planning EVstudio | Denver & Evergreen Architect | Colorado & Central Texas | Blog
Leave a Response